Shenzhen Xingyongwei Silicone Co., Ltd.

. Packaging silica gel, sealant silica gel, .silica gel, factory direct sales, free trial
. , silicone, potting glue, automotive electrical sealant, two-component thermally conductive potting glue. The factory passed,
. All products passed the certification, and some products passed the certification.
Manufacturer direct sales, free trial samples for new customers, welcome to call us for consultation.
Focus on silicone production for many years, more than one model can meet all your needs
Features and uses
.,
.It has excellent flame retardant, bonding, fixing, sealing, electrical, Insulation, moisture-proof, shock-proof, aging resistance and other properties.
.,
.The hardened silicone rubber can exert the original electrical properties of silicone and has good elongation at ℃
. ~
.℃ (It can also maintain its original rubber elasticity despite vibration and impact), and has weather resistance, heat resistance, and cold resistance.
.,
.Can be firmly bonded to most materials such as metal, glass, ceramic tiles, plastics and their alloys.
How to use and precautions

. According to the dosage, cut off the head of the nozzle head, install a special injection tool and extrude it before use, and solidify at room temperature
.The sealing cap must be fastened after use.

.. When using, the adhesive layer must be fully exposed to the air. The larger the contact area, the faster the curing will be. On the contrary, it will slow down or even not cure at all.

.. The thicker the glue thickness, the longer the curing time, and the higher the ambient temperature
.(
. It cannot be higher than
.℃
. )
The greater the humidity, the faster the curing speed of the adhesive layer, and vice versa.

.. This product should be kept dry and protected from high temperatures during storage and transportation. The effective shelf life is
. months. Products that have exceeded the shelf life can still be used after passing the inspection.
Clean the surface: Clean the surface of the adhered or coated object and remove rust, dust, oil, etc.
Apply glue and unscrew (or cut off) the cap of the hose, squeeze the glue onto the cleaned surface to make it evenly distributed, and close and fix the glued surface.
, Curing: Place the glued or sealed parts in the air and allow them to solidify naturally. The curing process is a curing process from the surface to the inside. Within hours (room temperature and % relative humidity) the glue will be cured to a depth of ~. If the glue is applied in a deep position, especially in parts that are not easily exposed to air, the time for complete curing will be If the temperature is low, the curing time will also be extended
After the operation is completed, the unused glue should be capped immediately and sealed. When using it again, if there is a little crust on the seal, just remove it and it will not affect normal use. During the storage process of the glue, a small amount of solidification may occur at the mouth of the tube. After being removed, it can be used normally without affecting product performance.
Product packaging
., aluminum tubes, plastic tubes.
. . . Main properties
. .
Model
Appearance white, flowing
Viscosity (.) ~
Specific gravity (℃) .~
Surface drying time~
Shore hardness~
Elongation at break ( ) ~
Tensile strength ( /) ~
Volume resistivity
Breakdown voltage (/) ~
Dielectric loss tangent
High and low temperature resistance ℃~℃
Address 1st floor, Industrial Park Building, Sanlian Community, Longhua Street, Shenzhen
(This article is from Shenzhen Xingyong Organized and shared for Thermal Silicone Co., Ltd.)